TSOC EZ-TEMPLATE LOW VOLTAGE INSTALLATION TOOL FOR SINGLE GANG WALL PLATES, BLAC
- Product Information
- Online Distributor
- Product Sheet
TSOC products are designed with the technical professional in mind to help save time and money. The EZ-TEMPLATE is a unique and simple tool used to help install a single gang low voltage wall plate more accurately and consistently.
1. TM-EZTMP01BK: EZ-TEMPLATE Tool
2. TMWBF-1CD: Low Voltage Mounting Bracket w/Screws
4. Drywall Saw
5. Manual or Power Screwdriver
Place the EZ-TEMPLATE on the DRYWALL in the desired location for the single gang low voltage wall plate to be installed. Adjust to required height (18-24 inches above the finished floor). Keep the bubble in the centre to ensure the hole is level. Use a PENCIL to trace the inside dimensions of the hole to be cut.
Place the DRYWALL saw tip along any section of the traced pencil line. Hold firmly in one hand and with the other hand firmly press against the handle of the tool forcing the blade to penetrate the drywall. Continue sawing along the lines until the inside drywall has been cut away.
Place the LOW VOLTAGE mounting bracket against the opening in the drywall and bend each tab toward the opening in the drywall. Once secure, use a manual or power DRIVER to insert the screws provided to lock the mounting bracket in place. Do not overtighten.
Load the single gang keystone wall plate with the desired voice, data or video keystone module and terminate or insert the corresponding cables. Then install the wall plate over the mounting bracket and insert the screws by hand. Continue to tighten using a manual DRIVER until complete. Do not overtighten.